Perhaps this has already been addressed. If so, please refer me to the proper page.
I just purchased a RW-10D Klipsch subwoofer to connect to my equally new Onkyo receiver. I read the Onkyo instruction for connecting thePowered subwoofer which state
"Using a suitable cable, connect the AV receiver/AV amplifier's PRE OUT SUBWOOFER to an input on your powered subwoofer as shown. "
It then showed a simple picture of a cable going from the PRE OUT subwoofer connection on the back of the Onkyo to a single "line input" hole on the powered subwoofer.
When with great confidence I turned to the back of my RW-10D subwoofer looking for a single input, i was very discouraged to see many inputs. Some were labeled "high level" left and right (positive and negative)........ far too many connections for my single cable output. Then I saw a right and left "line in", but I only have one out put from my receiver???? Do I need a cable that splits right and left???
Then I turned to the manual( useless in many languages) and there was a picture that said "LFE or Sub Output" which appeared to be a single cable going into the left hole of the "line in" pair. Is this where I connect??
Please help a newbie with this question as I have found the instructions from the two companies very confusing
Thank you so very much for your help
Patricia