Q-Man

new oak face board

still empty

fitting horn

false corner in place

Almost done with the false corner.

figuring out the new bottom and top so the bass horn can be mounted on it's side.

side view

290-16K driver

A little help from my son checking the angle.

designing it.

It's a Klipschorn bass horn on it's side in a unique false corner.

Buy some 7/8" wide edge banding. You might have to buy a roll of it, but you can sale what's left over on ebay. You can buy contact adhesive in a 17 oz. spray can. Glue on the edgebanding then trim it with a razor knive, but leave a little overhang. Sand the overhang flush with a hand held sanding block.

I thought a 5 mega pixel camera would show the room. I'll have to bring some light into the room if I want to take pictures. The room is almost as dark durning the day as it is at night.

right main and right front effect

center.

Left rear.

Right rear.

The left rear Imperial and LaScala.

The right rear speakers. the Imperial fires across the back and the LaScala towards the front.

My room is so dark it's hard to get a picture.

test

No I don't , but I'll take some for you. I just got a new camera and I need to try it out. You will laught when you see the legs, they are just some 1x3 boards screwed on the back. The speaker is still in the same crude condition as seen in the pictures that I just posted. When I built it I cut parts for two, but only assembled the one. The parts for the other speaker are still stacked on a shelf. I want to experiment with this speaker some more before I decide what to do with it. It is now serving duty as my rear center channel. That is why I stood it on end. I wanted the midrange horn and tweeter higher. I need to finish my Altec / Klipschorn to replace the Universiy. Then I can put the University in another room where I can play with it again.

seven

six

five