Krutz

Thanks for your advice, but you should try to be less patronizing. See?

I appreciate it. I think I'm on the right track now. Hopefully in a few years I can start helping people on these forums. One more question though, what is Full Band? I've looked around and I keep getting different answers from people. I'll take your advice and "not" use it, but I'm still curious about what it is. Thanks

I appreciate the advice, and not to mention the quick response too. I was reading somewhere on the web (not always the most accurate information) that I should set my speaker to about 10 - 20hz above the lowest range that my speaker can do. Thats where the low range cutoff is and my subwoofer will take care of the lower range frequencies. It mentioned that LFE is relatd to the subwoofer only, also that most LFE tracks don't go above 80hz. So would it make much of a difference if I set the LFE to 120hz? Does this sound at all correct to you. I trust your opinion over some random web page I stumbled upon. It looks like you have been posting and helping people for a while. Thanks Bill Matt(Krutz)

Im a noob to the audio and sound scene. I did the mic setup and didn't like the results. Im a little afraid to experiment with different frequencies because I really have no idea what Im doing, I have everything on factory defaults . A little guidance would be appreciated. Here's my setup. Amplifier\Reciever : Onkyo TX-SR605 Fronts : Klipsch RF 82 II Center : Klipsch RC 52 II Surround Right & Left : Klipsch RF 62 II Subwoofer : Klipsch SW-450