I don't know if the RW-10 is the same as the SUB-10, but the transformer looks to be the same with the same amount of pins. If I measure between pins 1 & 2, it reads an open. All other pins look to be ok on the input side. The output side looks to be all good as well.
Prior to me replacing, 2 MOSFETS before the input side of the transformer, a Thymistor right after the full wave bride rectifer, and a 200V 470uf cap, which is next to the transformer, all it would do is blow fuses. Now I can apply 120V, and it won't pop a fuse, but it won't power the amp circuit either. I'm reading a 165V next to that 470uf 200v cap next to the transformer, but no lower voltages after that.. I think I should be seeing around 60VAC on the output side of the transformer before it's switched to DC and then sent to the Power Amp MOSFETS..
The top of the transformer has the following: indigo 500126 Rev B / TWI 881692 B 0739.
I can't seem to track down any kind of matching part #..
I want this fixed!! and I'll fix it if I can replace all the blown parts.. That's if I can find all of the... Else I wonder if Klipsch will fix it.. Appears to be a bad amp design..