JohnWick2016

You are not the first one who said that to me so, one point to the rc62ii... It seems that the new center channels are not better than the reference II ones. Sent from my iPhone using Tapatalk

Rc-62II sorry!!! I have already corrected the mistake. Thank you. Sent from my iPhone using Tapatalk

Hello everyone. I have used the search but no one had the same question. Today I went to a shop near my place to buy an RC-62II to be partner of my RF-82II. When I arrive I noticed that they already have the new klipsch line, the premiere one, which usually doesn't happen that quickly in my country. So the doubt came to my mind and google couldn't resolve it yet. What would be better to get, an RC-62II or and RP-450C? As far as I read the 450 replace de 62II, or its replacement is the 440 o 250? I don't want to buy something that doesn't combine with my floor standing speakers. I will appreciate your answers and if I missed a thread asking the same, please tell me. Thanks. Sent from my iPhone using Tapatalk

Ahah ok great, thank you all for your answers, you have been helpful Sent from my iPhone using Tapatalk

I did not know that. So I will wait until the rx-a 3050 be available in my country to make the change. But at last what I don't completely understand is: if clipping comes out when you have a avr that handle less power that what needs the speaker and it happens with loud volume, as far as I read about it, why could be damage the speaker? Sent from my iPhone using Tapatalk

Great. Thank you for your answer. So I'm fine with it but if I can get the upgrade it would be better and I will have all my speakers potential? And one more question, perhaps you know. Sometimes with treble sounds I feel a bit of distortion, for example when I use my PS4. I set up DTS on the ps4 sound configuration. And about the avr I used the YPAO and nothing more, I didn't put my hands over the parametric eq. Could be a matter of settings? In that case where there is a topic or something in the forum that helps me to understand and use the eq? That's all, thank you. Sent from my iPhone using Tapatalk

Hello everyone. My first time here, I think I have chosen the right place in the forum to ask. I have a pair of RF82 II and a Yamaha Aventage RX-A1020. Knowing that the 82 work with 150rms and my receiver have 110, to be exact: Rated Output Power (20Hz-20kHz, 2ch driven) 110 W (8 ohms, 0.09% THD). Can get damaged my rf82? Would you recommend me to get a Yamaha RX-A 3040 which has 150w per channel? Thank you. Sent from my iPhone using Tapatalk