Tommy39

Hi, Thank you for the reply. I had followed the manual from the Yamaha A1060 and Klipsch, the extra pair of speaker wires were connecting the lower pair of RP260 binding posts to the Yamaha "Front Presence" binding posts labelled "SP1".

Hi, I am new to the setup of my home theatre system. I have an AV receiver Yamaha A1060, RF260 floor standing speakers, RP250C, R14-S surround, R-10SW. I was so careless that I didn't remove the jumpers when doing a bi-wire. While doing the YPAO with a mic on the Yamaha, the AV receiver shuts down when it was half way doing the calibration. I didn't realised it was the jumpers, the receiver was showing "Check SP wire". I did the YPAO a few times (The receiver shut down a few times). I just wanna to ask if I had damaged my RF260 speakers or its internal components? Thanks.