Hi guys ,
i hope someone,can help me out with the following issue .
I have a pioneer receiver Vsx 920 , so nothing special there.
I just bought a new Klipsch R-10 SW woofer , and i ran the MCACC to let pioneer fine tune the speakers and new woofer .
i have had the adjust knob at the back set to LFE and woofer gain at 40% as seen on picture below.
I have set the the "on switch" to "Auto"
And let it run..... he detects my speakers , detects the woofer and al well .
After running everything and pioneer is ready with the "fine tuning"
Then i start to watch tv and i wait..... but the subwoofer wont turn on automatically .
then i start up spotify ...no woofer... a movie.....no woofer
I have to keep switching the on and off switch to make use of its woofer .
I thought maybe its the wrong cable?
So i bought a new cable .. Oehlbach Nf subwoofer cable. still nothing , so i bought another cable of Monster subwoofer 400 sw cable.
still nothing...
I ran the MCACC again... checked the setting...i thought , maybe the volume was to low on the woofer.
i noticed it was set to -10 DB ... so i switched it up to 0 DB , but stil no luck.
I did a Hard reset on my reciever...and once again let MCACC run its course.... no luck
Now im ran out of ideas, what to do....to make it work on auto setting....