EcuaJoka
-
Posts
6 -
Joined
-
Last visited
Content Type
Forums
Events
Gallery
Posts posted by EcuaJoka
-
-
I had it setup with audyssey and the h2’s were assigned to the LF ports from the speaker. With no pins.
So if it’s unnecessary, then these speakers just have an extra set of ports in case needed. So in conclusion, I just need to connect the height speakers and the HF ports from the speaker, to my receiver and leave LF ports on the speakers alone?at this rate, I’m getting a sound bar 😂😭😭
-
22 hours ago, The History Kid said:
Not sure what the question is. There's 2 speakers in the R-26FA, you only need to connect two terminals. See the diagram I posted in this thread. You connect the stand-alone terminals to height channels, and one of the lower 2 to the main.
No, you should be using the copper strap to connect the two lower terminals to each other and run only one set of wires from that lower set to your AVR. See the diagram.
I was able to connect the speakers this way. It’s it correct?
speaker / Receiver
Atmos - height 1 L&R
HF to front L&R
LF to height2 L&R
Can I use the k4B-2B Bi-Wire Speaker Cable? Which is the 4 banana plug to 2 banana cable. I may have misplaced the pins.
-
I was able to connect the speakers this way. It’s it correct?
speaker / Receiver
Atmos - height 1 L&R
HF to front L&R
LF to height2 L&R
-
8 hours ago, EcuaJoka said:
I also received these speakers, but as a gift. So would i need a Bi amp cable? The cable that has 2 banana connections on one end, and 4 banana connections on the other end. I have a Marantz 6013 as my amp.
Thanks.
Steve
I figured it out.... I will let you know
-
I also received these speakers, but as a gift. So would i need a Bi amp cable? The cable that has 2 banana connections on one end, and 4 banana connections on the other end. I have a Marantz 6013 as my amp.
Thanks.
Steve
Connecting R-26FA
in Home Theater
Posted
I’m just going to bi wire them with 4 to 2 banana cables, and call it a day. And hopefully in the fall get a power amp.
thanks.