William Blaak

Awesome! Thanks for that, confirms my above. The rest of the hook up and wiring is pretty straightforward, it was the bass bin wiring so I can use the current jacks, and keep the disconnects to a minimum.

Very nice!

AHA!! I 'think' I have it figured out. I just need to disconnect the inductor from the fuse, connect the + and connect the - to any ground point. And... actually... I don't think I need to disconnect that cap since that is just to ground, and disconnecting the inductor/original speaker leads takes that all out of the circuit(?).

Hi Khornukopia, Thank you for the reply and suggestions. I very much like the idea of just replacing and keeping original wiring in tact. Unfortunately though, I don't have any access to a shop or my tools at the moment. But I like this

HI Travis, thank you for the welcome, I appreciate it. And yes, I sure hope so!

Hello All, I have been a lurker for a while but I finally have something to post. I have a set of Crites AK-3's to replace the stock AK-2. These are the ones with the woofer part of the crossover in the bass bin. How to rewire is not straightforward (to me) as far as the bass, I can build cabs all day but wiring confuses the hell out of me. Has anyone else done this specific swap. I would like to keep the fuses in the circuit. And/or is there by chance a wiring diagram or instructions anywhere, didn't seem to be anything on the Crites site. Thankyou in advance for any input!