Good morning everyone. I am in the process of building my home theater which will consist of 7 R-5502 in walls, 4 CDT-5650 in ceilings and 3 (left, right and center) RW-5802 in wall subwoofers powered by the RSW-500. The rest of the system will be powered by a new receiver that I have not yet chosen due to my uncertainty on how to connect the passive subs. So that leads us to my question...How do I connect the in wall 5502s and get a full range signal (or set to large in the AVR) and still get a full range signal from the receiver sent to the RSW-500 subwoofer amp to power the in wall subs? My only guess is if the AVR is capable of powering the R-5502s (LCR) with it's built in amps and also send out a full range signal using the LCR pre-out (RCA) to the RSA-500 to power the RSW-5802s. I hope I am not confusing anyone but I just want to make sure I get all the right equipment installed up front and not have to worry about it when it's time to watch a movie. Thank you in advance