The MC cartridge I am/was considering is a Hana Blue. https://www.hanacartridges.com/products/hana-umami-blue
Stylus
Microline
Cantilever
Boron
Magnetic Circuitry
Pure Iron/Cryo Treatment
Coil Wire
High Purity Copper
Output Level
0.4 mv
Output Balance
0.5/1kHz
Trackability
70 µm/2g
Channel Separation
30dB/1kHz
Frequency Response
15-50,000Hz
Coil Impedance
8Ω/1kHz
Suggested Load Impedance
> 80Ω
Magnet
Alnico
Vertical Tracking Force
2g
Cartridge Weight
10.8g
Body Material
Duralumin (A7075)
Body Finish
Melamine Thermosetting Process (MTP)
I have a Vincent Pho 701 preamp.
https://www.vincent-tac.de/en/product-types/phono-preamplifier/pho-701.html
Technical Specifications
Frequency Response: 10 Hz – 20 kHz
Harmonic Distortion: < 0.05 % (20 Hz - 20 kHz)
Input Sensitivity: MM: 58 mV, MC: 6.8 mV
Signal-Noise Ratio: MM: > 81 dB, MC: > 69 dB
Input Impedance: MM: 47 kOhm, MC: 99 - 1000 Ohm (adjustable)
Input Capacity: MM: 15 pF - 350 pF (adjustable), MC: 15 pF
Output Impedance: 250 Ohm
Amplification Factor: MM: 40 dB, MC: 60 dB
Max. Power Consumption: 15 Watt
Inputs: 1 x Stereo RCA
Outputs: 1 x Stereo RCA, USB (24 Bit / 192 kHz)
Tubes: 1 x 12AU7
My amp is an Elekit 8600S. https://www.elekit.co.jp/en/product/TU-8600S
SPECIFICATIONS
●Tubes : 300Bx2, 12AX7x1, 12AU7x2 * Tubes are not included
●Rated output : 9.2W+9.2W ( THD 10% )
●Rated input : 270mV
●Rsidual noise : 36μV(IHF-A)
●Frequency response : 15Hz-40kHz(-3dB)
●Input impedance : 50kΩ
●Output impedance : 4-6.3Ω, 8-16Ω (Select by the SW on the rear)
●Input terminal : LINE x 1
●Output terminal : Speaker output terminal:Gold-plated screw terminal (Banana plug usable)
Headphone terminal :6.3mm headphone jack
●Power voltage : AC115/230V 50/60Hz (3P inlet)
●Power consumption : 90W