Search the Community
Showing results for tags 'stephens 103lx'.
Found 2 results
So, I am slowly restoring an old set of Khorns. I just took some measurements of the latest configuration and I'm wondering if this is looking like it's supposed to. Set up: UMIK 1 / REW / about 3 feet off the ground / 3.5 feet from front of Khorn / 1/6 smoothing Woofer: Stephens 103LX (16 Ohm, DCR ~ 10 Ohms) // mounted on slide-in motorboard, with 6"x13" slot Mids: University SA-HF + K-5-J Highs: K77 Tweeter (square magnet) Crossover: I built the ALK Universal crossover with Solen caps and Litz inductors on a k-500-5000 crossover board (1954). I'm using the old autotransformer on the board and the squawker is connected to the -3 and 0 tabs on it. Here are the measurements. Is the woofer response supposed to look like that? It looks like it's not being properly attenuated on the upper end.