minasu

Artto, Thank you for you good confirmation about 0.85v, I have tried again with this level the shound is more tight and more attractive, now I don't afraid about heat of 6336 becasue it is normal Pls kindlysend attachment to me. Again thank you all of you about MQ-80 bias adjustment. Regards, Hoang

Artto, As your advice but it seems that bias 0.85mv overload for MQ80, the 6336s very hot --> I go down to 0.7mv, Now sound is better but not best. KMQ80 is the same MQ80, could you mail KMQ80's manual to me? Highly appreciated Your assistance. Regards, Hoang

Hi All, I have used nice speaker from Tannoy - It is ARUNDEL model use K3839 driver. As my opinion, the speaker is very good from Mid-Bass to low Bass but the speaker have some problem for high section (mid to high). I heard somebody talk about Tannoy crossover is not the best, custom crossover will improval this problem of the speaker. Is there any person well know about this matter, pls kindly assistance. Regards, Hoang

Seti, Thank you for your ebay information. I cannot find any the user as your mention "IBSlammin" on forum. Could you check again?

Chuck, Thank you for your information, I checked the website but they don't have MQ-80 manual. But I can download manual for my preampli CL-32. Thanks Hoang

Hi All, I just buy Luxman MQ-80 with failure 6336s. Now I already replaced good condition (about 70%) 6336s, now I would like to improve its sound by adjust DC balance and Bias. Could you show me how to get MQ-80 manual, schema, DC Balance and Bias adjustment? I am also looking to buy two NOS 6336s. Your assistance is very much appreciated. Hoang