drumdude

Hello William and thank you for your reply. Yes I do have that pin out and what I can not distinguish is the JK201:1 through :6. On the pin out it shows all six terminals lined up. Mine has two rows of 4. I can tell by looking at them that two do nothing or are a ground. Nothing is labeled on the board. I tried to guess by tracking down where they go. However I am a novice and want to make sure that I don't solder to the wrong terminal and fry it for good. Thanks, Earl

Hello I'm new here and have loved my 2.1 system for about 10 years. Except for that damn connector. I have read many posts on here and most all refer to the din connector cable or male end. I wish mine was that simple. I have broken pins on my internal conection on sub. I have taken off the broken piece off the IO board. On both pin outs I have found, none of them tell me which pins go where. I know that JK201-1 is for +15 v, JK201-2 is for sub etc. It has eight possibilities.Two rows of four not six on top of each other like the pin outs show and not marked on the board. I have a pin broken out of one of the six so I was going to solder my connections from the cable straight to the IO board. Out of these eight, what goes where???

Hello I'm new here and have loved my 2.1 system for about 10 years. Except for that damn connector. I have read many posts on here and most all refer to the din connector cable or male end. I wish mine was that simple. I have broken pins on my internal conection on sub. I have taken off the broken piece off the IO board. On both pin outs I have found, none of them tell me which pins go where. I know that JK201-1 is for +15 v, JK201-2 is for sub etc. It has eight possibilities.Two rows of four not six on top of each other like the pin outs show and not marked on the board. I have a pin broken out of one of the six so I was going to solder my connections from the cable straight to the IO board. Out of these eight, what goes where???