klipsch1

its amazing that the the k55m were soldered backwards . the + and - were switched so maybe I was not getting the right sound out of them when they were on the horns? in any case the k55v dual phase plug mids sound very nice. I replaced the diaphragms with new ones from bob crites. the k55v also sound a little less harsh. maybe its because the k55m were connected the wrong way?

Are you sure ? As far as I know , only the k55V had the dual phase plug design.

I just replaced the stock k55m with older k55V ( dual phase plug ) and it sounds amazing. I also found out that the previous owner had the + and - mixed up at the swuaker.

Yes I’m aware of that , but I think the previous owner may have altered the cross over and that is why I wanted to confirm. So that when I change the mid k55m to the older k55V , I don’t switch the + and - by mistake.

thats great, because from what i see on my crossovers, i think the squawker and tweeter are wired wrong. but i will double check again. thanks so much.

Hi all. I need some help finding the positive and negative connections on the AK3 crossovers in my klipschorns because I want to change the mid drivers to k55v alnico and I think the previous owner played around with the wires and since they are not marked red or black on the crossovers I was hoping someone can tell me where exactly is the red and black for mids and tweeters on the crossover. since they are soldered and not marked, I don't know what wire is positive and what wire is negative. thanks

so I purchased new fuse holders today and when I got home, I found out that they were to small diameter and went through the hole so now I have to find fuse holders that will fit and not go through the hole.

I have a pair of k55v dual phase mids. Should I put them on and will they sound better on the k401. Horn?

Thank you

Do you know if it’s Birch? Or some other wood?

Hi does anyone know the meaning of KB FIN BLK #17 grill is on the side of speakers ? Also what year are my klipschorns? 036298426 is serial number ? Thanks

I just need to replace the fuse holder

I sent Schu the pic so he can post it. thanks again. you guys are the best.

ok so i would like to thank everyone . the problem is a broken fuse wire.

ok I will take a ohm meter and check reading. thanks for everyones patience . I will post the results soon.