RoZis

I had the same issue on my R-112SW and replace beside the resistor, capacitors in front and the one on both sides. Here my shopping list

Yes, I did it this way. To be honest, it was not easy for me, even though my soldering experience is not that bad. My circuit board became porous due to the resistor being too hot. The trace of C19 came loose up to behind ZD6. I tinned it and made a good connection to C19 with a thin wire. Soldering eye was not possible for me, everything was much too tight. 112SW works again, that's the main thing 🙂

Thank you. Picture is not mine, mine is already clean.

Hello, Had tried to repair my R-112SW At C19 the Conductor path is broken up to the back (positive side of capacitor) and I can't see where it ends on my board. I would like to solder a wire to repair it. Here is a picture of a board (not mine), can you please mark the point where C19 should connected to?