senzlez2
-
Posts
28 -
Joined
-
Last visited
Content Type
Forums
Events
Gallery
Everything posted by senzlez2
-
I got 2 used stock crossover boards for the bass section mine was burnt up, so I took the parts on that instead, speakers are back together thanks for the help anyway
-
im confused are you a retard ?
-
why the F are you spamming my post with troll comments, you have nothing constructive to come with. are your life so miserable
-
I gave up on crossover took the parts off, cleaned up 2 of my tweeter board that was salvageable and found 2 used bass section boards second hand used maybe i was lucky thanks for the help anyway
-
yes im about to follow your layout, on both crossovers, I will report back thanks for the help so far
-
the bottom of the picture is the connection for drivers, top is the connection for terminals
-
I have measured without the straps its about the same, on tweeter and woofer, I also have measured if the tweeter have open circuit wich it does I get continuity through to the terminals , I think its on the woofer circuit its something wrong for its always when bass kicks in the amp shuts down
-
0.0.4 something isn't right
-
I have desoldered and bent the wire upwards its not touching the resistor, I tried to measure the ohm impedance again its the same, on both 0.0.4 on speaker terminals I have them all connected on the floor drivers and crossover , should it not be about 8ohm total impedance on terminals all connected together ?
-
yes it does its one of the ground cables you pointed out I put on
-
yes it is
-
ok I have measured all the drivers from both speakers , all measure about the same so its nothing to do with the drivers, is there polarity on the coils? there is no polarity on the caps and resistors I used, can someone go over the crossover I built it should be right, im at wits end, maybe I should have just bought a second hand crossover
-
yess it fluctuates but it settles at 0.0.4
-
with the same measurement ohms and 200 settings on multimeter as I measured the other drivers
-
it goes from 1.2 ohms at first and down to 0.0.4
-
I measured the drivers from the other speaker , the only reading I could get was in ohms and a 200 setting, tweeter 5ohm, and the bass drivers 9.7 ohm each
-
ok so how do I measure DCR what settings on a multimeter, I tried searching around
-
I have only 1 speaker hooked up to my amp with new crossover,
-
hello again, I has attached ground on tweeter and bass section, its still cutting out when pushing the volume, maybe I have changed the impedance of the whole speaker ? im using a Yamaha a-s1200
-
thanks for the help mboxler, I have only used the speaker once with the amp, Im now in the process of disassemble and attach ground
-
I have posted this if you care to take a look at it regards K
-
hello I built a new crossover for my Klipsch rf-83 my old crossovers was burnt on 2 of the boards, I just need to double check if this is right, probably not. its coming sound out and the speaker lacking a little in bass, but when I push the volume up the amp cuts out, I followed this crossover schematic I just used the leads of the caps and resistors and. coils mostly, it doesn't look pretty I used the stock coils from the bad crossover boards, regards
-
hello again, i have built my own crossover for a set of speakers Klipsch RF-83 with new parts I followed the schematic. but when the volume and bass is set, the amp cuts out, do you have an email I can contact you to get you to look at the crossover if something I did wrong? , looks like you know your crossovers for Klipsch, if you can
-
what measurment gear are you using?
