senzlez2
Members-
Posts
28 -
Joined
-
Last visited
Content Type
Forums
Events
Gallery
Everything posted by senzlez2
-
I have desoldered and bent the wire upwards its not touching the resistor, I tried to measure the ohm impedance again its the same, on both 0.0.4 on speaker terminals I have them all connected on the floor drivers and crossover , should it not be about 8ohm total impedance on terminals all connected together ?
-
ok I have measured all the drivers from both speakers , all measure about the same so its nothing to do with the drivers, is there polarity on the coils? there is no polarity on the caps and resistors I used, can someone go over the crossover I built it should be right, im at wits end, maybe I should have just bought a second hand crossover
-
I have posted this if you care to take a look at it regards K
- 58 replies
-
- cabinet bracing
- crossover refresh
- (and 4 more)
-
hello I built a new crossover for my Klipsch rf-83 my old crossovers was burnt on 2 of the boards, I just need to double check if this is right, probably not. its coming sound out and the speaker lacking a little in bass, but when I push the volume up the amp cuts out, I followed this crossover schematic I just used the leads of the caps and resistors and. coils mostly, it doesn't look pretty I used the stock coils from the bad crossover boards, regards
-
hello again, i have built my own crossover for a set of speakers Klipsch RF-83 with new parts I followed the schematic. but when the volume and bass is set, the amp cuts out, do you have an email I can contact you to get you to look at the crossover if something I did wrong? , looks like you know your crossovers for Klipsch, if you can
- 58 replies
-
- cabinet bracing
- crossover refresh
- (and 4 more)
-
what measurment gear are you using?
- 58 replies
-
- cabinet bracing
- crossover refresh
- (and 4 more)