Map63Vette

Does anyone happen to have any schematics for these boards? I have a bad amp that came out of a Klipsch sub 10 my dad has and was interested in potentially pulling the crossover out of it to use with a bass shaker setup. I have a small amp that is already well suited for the shaker, but it doesn't have any frequency control. I plan to wire it into the LFE output on my home theater setup, but need to limit the low pass filter below what the sub needs. Looking at the amp it seems like this should be pretty easy to do as I think all the processing happens on a separate board with the crossover dial, but I'm not sure what the pinout for the connector to the board is. Looks to be something like 6 wires, so guessing something like power and ground, signal in, and signal out, but would be nice if I could trace it out on a schematic instead of having to reverse engineer by following circuit traces.