Search the Community
Showing results for tags 'k-1005-k'.
Found 5 results
-
I'm looking for a K-1005-K driver for mid '90s Klipsch 4.2. Specifically, I sliced the outer cone this morning. Klipsch does not have a replacement driver though I should have asked if they have any cones (unlikely). Your help is appreciated.
-
I'm looking for a replacement driver, for the early '90's Kipsch 4.2 speaker(s), in particular one K-1005-K active driver. I have checked with Kipsch directly and that part is no longer available. I'll search the internet, but if you folks know of a source, new or used, that would be appreciated. Kind Regards
-
Very good condition... removed from a perfectly functioning KG 4.2. No surround damage, pushed in dust cap or voice coil noise. Includes original gasket and 4 screws. $80 Located in the Western burbs of Chicago, near Naperville. (I-88 and route 47 area) Local pick up preferred. I can demo it in the garage if you like. Shipping add $15 and I'll cover the paypal expense.
-
Hello all, A10" woofer from a set of KG 4.2's was old, tired and making noise and needed to be replaced. I'm looking either for a single used k-1005-k (From a Klipsch KG 4.2) or suggestions on two affordable replacement drivers that are similar and will work well in the 4.2 cabinets with the passive 10" radiator. I don't want to spend a ton as these are almost 30 year old mediocre speakers that will most likely end up spending the remainder of their lives serving as garage duty speakers... I'm thinking no more than $150 for a pair of replacement drivers. I'm looking for drivers that have a higher efficiency rating (around 93dB or greater) to keep up with the efficiency of the tweeters. So far I found these from parts express: https://www.parts-express.com/dayton-audio-pa255-8-10-pro-woofer--295-030 Nominal Diameter10" Power Handling (RMS)300 Watts Power Handling (max)600 Watts Impedance8 ohms Frequency Response46 to 3,500 Hz Sensitivity92.6 dB 2.83V/1m Voice Coil Diameter2" Magnet Weight50 oz. Any other thoughts or suggestions?
-
Hello all, I'm looking to buy a single K-1005-K 10" woofer for a KG 4.2 project that I'm restoring. I'm also open to suggestions for other driver options that will work reasonably well in this enclosure. If I go this route, I would be looking at buying 2 drivers so they would match. I don't want to go crazy with the drivers, as these are going in almost 30 year old speakers! (Budget is up to $150) Thanks in advance.
