Search the Community
Showing results for tags 'powered sub'.
-
Hi guys, not sure if anyone has any of these or if I will just succumb to making my own. I need a pair of internal sub wires. One for positive and one for negative terminal leads with female adapters on each side. Figured it was worth a try to see if anyone had a pair floating around that they didn't need. Thanks, Tim
- 3 replies
-
- sub
- powered sub
-
(and 2 more)
Tagged with:
-
This would be for a Klipschorn, but it might also be for a LaScala, a Belle, or a Heresy. I am wondering what might happen if I used a 15 inch powered subwoofer in a Klipschorn. The way this might happen would be to put the woofer itself in the Klipschorn (it would be one that needed a new woofer anyway) and run the woofer leads on the Klipschorn crossover to the subwoofer amp. This would mean that the subwoofer amp would need to have speaker level inputs as well as line level inputs. You should be able to take the leads from the crossover and split the pair into two pairs for each speaker input in the subwoofer amp, putting a mono signal to each channel in the subwoofer amp. If successful, you might strengthen and extend that bottom end. Ideally, you might take a Klipschorn all the way down to 20 hz. Having said all that, it appears that a Klipschorn crossover sends signals below 400 hz to the woofer. A powered sub would likely cut off at 100 hz or 150 hz, leaving a gap for signals under 400 hz and over that cutoff frequency. We don't want that. So, would it be possible to bypass that control on the subwoofer amp so that none of the signal was cutoff? Then, (theoretically) the Klipschorn crossover would send everything under 400 hz to the subwoofer amp and in turn that would be passed on to the subwoofer's woofer, now the woofer inside the Klipschorn. If would be easy enough to mount the subwoofer amp somewhere around back of the Klipschorn so it looks good. Although all frequencies could then go through, the Klipschorn crossover would not let high frequencies ever reach the subwoofer amp. Before you make the "drawing a mustache and/or glasses on the Mona Lisa" comment, note that I did NOT say I was going to do this. I said I was wondering about it. I do realize that if this were done, it would have to be done two times for two speakers. Also, the cost might be ridiculous. However, I would like to stay focused on the "what if" and not go to the "why would you?". So, is it possible (and reasonably easy) to bypass the control on a powered subwoofer amp that sets the cutoff frequency, such that all frequencies received go to the amp and to the woofer? If some models could allow this, which ones are they? What other technical issues or challenges or tasks might arise and how would they be dealt with? FYI, I have a very old Klipschorn cabinet in very good shape and I am going to restore the guts and use it as a center channel, flanked by a pair of LaScala's. I would run a mono signal to the Klipschorn and a stereo signal to the LaScala's, using separate amps. Once I get the Klipschorn up and running, the rest is relatively easy. I don't mind having to use multiple amps. So, let the conversation begin.