Search the Community
Showing results for tags 'rf-7 iii'.
Found 1 result
Hello everyone! I'm new to this forum, but love all the shared info - I'm learning a TON! In the next couple of months I'm gonna get serious about a real HT setup and currently in the planning stages. I wanted to run my potential setup and speaker placement by this community and see if there is anything I'm missing to setup a Dolby Atmost 7.1.4 configuration. I've attached 2 drawings of my room layout to help visualize what I'm working with. Any and all feedback is welcome to help improve and optimize my setup. My grid was every two boxes equals 1 ft approx. Thank you! Front: RF-7 III Center: RC-64 III Rear: R-51-M Rear-Surr: RP-502S both Rear speakers and Rear surrounds mounted on 30 inch speaker stands. Atmos front mounted above front left and right speakers: RP-500SA Atmos mounted above the couch area 10ft off the ground. RP-500SA Sub: considering hiding it in the rear corner of the room instead of in the front: (the front speakers I've heard punches good bass + lack of space) SPL-120 AV: Denon AVR-X4400H or X4500 depending on whats cheapest and available. Paired with a XPA-3 Gen3 AMP or Outlaw 5000 powering the front stage. ( I must admit I'm not 100% clear on the difference between that emotive 3 channel vs. the outlaw besides the obvious fact that the outlaw has 2 additional channels. The Emotive seems like it has a lot of power for those 3 channels comparatively.) Thanks again for any advice, Spencer