danmarycap Posted May 17, 2009 Share Posted May 17, 2009 I upgraded the speaker wire on my ProMedias to 14 gauge (and soldering the rca connector onto one end was NOT fun). But now I find the 14 gauge wire is too big for the tiny, spring-loaded speaker terminals on the back of the GMX 2.1 sub-woofer...and the connection is just cheesy. Has anyone replaced the cheap speaker wire terminal with a better one that uses higher-quality connections, like the banana plug? If so, where did you find the right size terminal and was the upgrade difficult? Dan Quote Link to comment Share on other sites More sharing options...
PhilipTobias Posted June 26, 2010 Share Posted June 26, 2010 >>Has anyone replaced the cheap speaker wire terminal with a better one that uses higher-quality connections, like the banana plug? If so, where did you find the right size terminal and was the upgrade difficult? Yes, I did this yesterday. While it is too late to help the original poster, perhaps this reply will help others who are looking for an answer. I replaced the broken (and yes, very "cheesy") terminal strip on my ProMedia 2.1 (not sure about the GMX designation) subwoofer with a higher-quality terminal strip. The replacement I found at a local electronics supply house was a Philmore Terminal Strip, Push to Insert, No. 1979. This is made in Taiwan and cost me $2.95. Unlike the original Klipsch part, which mounts from the inside, the Philmore unit bolts on from the outside, covering the original opening.The bolt holes on the Philmore strip are close enough to the original that no drilling was required. Just insert one bolt on either side and tighten with a washer and locking nut. The Philmore strip has four terminals. There are only three wires connecting the older part. So once you remove the wires from the intermediate circuit board that connects to the Klipsch terminal strip, you connect two of the wires to the two + terminals; connect the remaining wire to one of the - terminals, and use a jumper wire from that to the other - terminal. With my particular unit, I believe the white, green, and red wires reconnected like this: Left Right + - - + W, G G, R After acquiring the parts and removing the back cover of the subwoofer to access everything, it took about 20 minutes to replace and resolder the terminal strip, then a few minutes more to reassemble and test. The new terminal strip is much more robust. Not sure though what types of connectors it will handle, but it did work with the heavier-duty cables that Klipsch sells. Hope that helps. ...pt Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.