daltrey Posted April 3, 2002 Share Posted April 3, 2002 I have just acquired a set of these and want to replace my old speakers which are bi-wired.The popular consesus on these board is to y-split a sub cable from the sub out of the reciever to the the LFE in,and use the top set of terminals on the RP-3's leaving the metal strip in place. Since my set-up is already bi-wired,I was wondering if I should still keep the system tri-wired or not. I was using some pretty decent Kimber Kable 14ga. for highs and some not quite as good 12ga wire for my bass response.Should I just run the Kimber Kable where it is more detailed than the 12 ga wire?Or will I notice a difference? Quote Link to comment Share on other sites More sharing options...
boa12 Posted April 3, 2002 Share Posted April 3, 2002 daltry, yea that's fine & dandy to bi the top & bottom posts (just make sure you take off the jumpers). dk on the quality issues, but i'd use the heavier gage on the low (mid bass) posts & kimber on the highs. as u said run the interconnects to the rp's lfe in if you're using the filtered sub out of the preamp. u can either y-split to both rp, or use the lfe out of 1 rp to go to the lfe in of the other rp (daisy chain). ------------------ My Home Systems Page Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.