Jump to content

Need help with a Denon AVR-X3300W Receiver!


Recommended Posts

I have a Denon AVR-X3300W receiver.  Here is a link to the specifications on the reciever if it is needed to answer the question.  https://www.crutchfield.com/S-SO67d6QfvZx/p_033AVX3300/Denon-AVR-X3300W-IN-Command.html  It is capable of 7.1 surround or 5.1.2 Atmos according to the manual.  It has 7 Channels, 105 Watts RMS, and 4 Ohm Impedance.  The speakers I have right now are as follows:

2xRP-260F (Front left and right)

1xRP-440C (Center)

2xRP-240S (Surround left and right)

1xR-115SW (Sub)


I was wanting to hook this system up in a larger room in the basement.  This is a larger room so I was hoping to add 2xRP-150M speakers in the rear and 2xCDT-5650-CII in ceiling speakers.  I was hoping that the channels going to the two surround 7.1 speakers in the back could also push the in ceiling speakers however I don't want to under power any of the speakers or hurt the receiver.  Does anyone know if this is possible to do or would i need to buy a new receiver to accomplish this task?

Edited by justinra
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...