bucking magnets

[boa12]

looks like i'll have to be going this route w/ these klf-30 so close to the sony. color's ok, but horizontal lines are skewing toward the upper right of screen - pretty much right toward the mid horn of the right klf.

before i do it, wondered if i can just take out each driver seperately(phillips screws) or should I, along w/ the epoxy, buy that star torque wrench & drop out the whole front panel (i ordered only the tweet & mid magnets for now)? any other helpful tips? thanks.

------------------

Klipsch KLF-30 (front), KLF-C7, Cornwall I (rear)

Velodyne HGS-18 sub woofer

Monsterbass 400 sub interconnect & Monster S-12 cable

Sony STR-DE935 a/v receiver

Sony DVP-C650D cd/dvd player

Sony Trinitron 27" stereo tv

Toshiba hi-fi stereo vcr

Technics dual cassette deck

Technics direct drive turntable

Scientific Atlanta Explorer 2000 digital cable box

2nd room:

Klipsch RF-3 (front), RC-3, cheap little Technics (rear)

Kenwood KR-9600 AM/FM stereo receiver (vintage '75)

Teac PD-D1200 5-disk cd player

Sega Genesis game player

Sub: None yet

rock on!

[Guest BobG]

I am not understanding the question. The front panel is not held in place by torx screws. In fact, in the case of your pair, I guess the front panel is not held in by much at all.

I think you understand what it takes to fix the panel problem, but how does the torx driver enter into this?

[boa12]

bob, my stupid. i talked to trey & he mentioned something about torque screws (maybe inside when i take the horn/drivers out?). anyway i took the grilles off & glanced at the panel & saw these holes - well

they're the holes for the grille to go into

so i should be ok when the bucks arrive. bet after i put those on i'll find it's the woofers.

this must be the biggest service problem for you w/ the klf. wish they were shielded already, but this aint no perfect world.