lovemyhorns Posted September 22, 2003 Share Posted September 22, 2003 I had seen mention before of removing the diode tweeter protection and putting in place a polyswitch and resistor instead. What size resistor(ohms & watts?) and how do I wire it all in (are the polyswitch & resistor in parallel and this hooked up in series inline with the tweeter (+)??) I currently have the K-horn with AK-2 crossover if it matters... thanks! Quote Link to comment Share on other sites More sharing options...
sfogg Posted September 22, 2003 Share Posted September 22, 2003 "What size resistor(ohms & watts?) and how do I wire it all in (are the polyswitch & resistor in parallel and this hooked up in series inline with the tweeter (+)??)" I used a 100ohm 25w resistor and a 1/2amp polyswitch. The wiring is as you said.. the two are in parallel and that is in series on the tweeters positive leg. Shawn Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.