HydrogeN Posted September 16, 2004 Share Posted September 16, 2004 I have the 4.1 speakers for my PC. I had issues with the volume control know emitting niose when I adjusted the volume. So I purchased the CP-1 replacement for it. I followed the instructions that came with it, now I get no power on the new one or the old one. Does anyone have a solution for me. If I would have known that this was going to eliminate my system I would have lived with the noise. Thanks for any help you may be able to provide. Quote Link to comment Share on other sites More sharing options...
HydrogeN Posted September 16, 2004 Author Share Posted September 16, 2004 I have been reading some other posts on the same issue. I will retry the fuse again, but it looked to be fine. If I were to replace it for a shot in the dark, could I just get a replacement fuse at a local hardware store or is it some thing that has to be exclusively for these speakers Quote Link to comment Share on other sites More sharing options...
HydrogeN Posted September 16, 2004 Author Share Posted September 16, 2004 OK, I replaced the fuse and still nothing. I checked to see if there is power coming in on the white and black cables and I am getting power. But it is not giving any power to the preamp.What could be the cause and can I get it fixed? Quote Link to comment Share on other sites More sharing options...
rodspc Posted November 7, 2004 Share Posted November 7, 2004 i bet you have a fried resistor on the top small board once you pull the panel off the back of the sub. i have one that is dead myself. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.