HydrogeN

OK, I replaced the fuse and still nothing. I checked to see if there is power coming in on the white and black cables and I am getting power. But it is not giving any power to the preamp.What could be the cause and can I get it fixed?

I did post there as well. I will also try and call that #. Thanks

I have been reading some other posts on the same issue. I will retry the fuse again, but it looked to be fine. If I were to replace it for a shot in the dark, could I just get a replacement fuse at a local hardware store or is it some thing that has to be exclusively for these speakers

I have the 4.1 speakers for my PC. I had issues with the volume control know emitting niose when I adjusted the volume. So I purchased the CP-1 replacement for it. I followed the instructions that came with it, now I get no power on the new one or the old one. Does anyone have a solution for me. If I would have known that this was going to eliminate my system I would have lived with the noise. Thanks for any help you may be able to provide.

I had the same issue. I found the CP-1 and installed it. Now I get no power on the new pod, and no power on the old one either.I even looked to see if maybe a fuse had blown but no dice. Now I have a 5 piece door stop. Any advice.

I have the 4.1 speakers for my PC. I had issues with the volume control know emitting niose when I adjusted the volume. So I purchased the CP-1 replacement for it. I followed the instructions that came with it, now I get no power on the new one or the old one. Does anyone have a solution for me. If I would have known that this was going to eliminate my system I would have lived with the noise. Thanks for any help you may be able to provide.