jabrax Posted June 1, 2006 Share Posted June 1, 2006 Hi all...New to the forum AV yamaha rx-v757 7.1 - Sub ksw10 The only way I can get my sub to play is to use the auto setup feature of subwoofer. It sets my mains to large, sub to swfr, xover 40hz. I like the low in and 2-channel, so I set the sub to both from swfr and xvr to 60HZ. Things run very nicely with this setup (autosetup is not bad at all ).....Problem comes after I shut the system down for awhile and on 1 or two occasions acuatually stopped running while system was on. The only way to get the sub to re-engage is to run the autosetp feature again. I am useing the rec subout with Y cable to the sub. Set to "on" all of the time. (However, I do have the sub power down when I shut down the system. This happens because I have it plugged into power filter that shuts it down along with other components. I have tried setting speakers to small (polk lsi9) sound much better large. Tried disconnecting the sub and resetting the receiver, no luck. I'm really getting desparate here..... Anymore ideas?[*-)] Quote Link to comment Share on other sites More sharing options...
oldbuckster Posted June 3, 2006 Share Posted June 3, 2006 Try moving the Y connector to the sub: use the single wire from the receiver to the Y connector plugged into the sub. Do Not use the Y at the receiver plug. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.