TauRus Posted August 9, 2008 Share Posted August 9, 2008 Disclaimer: I am not a sub maniac, a single Klipsch RSW-10 sub paired with my old Klipsch Reference setup (RF3IIx2, RC3x2, RB5IIx2) does the trick for me. I recently upgraded my old trusted Denon AVR-3803 with a Pio Elite VSX-92THX. With that came MCACC. I know the true audiophiles never use MCACC for audio Nirvana simulation, however this is just a family room setup, and with the family room being an absolute most horrible setting for a home theater setup, I figured I cannot do any more damage by using the MCACC. ...And I am not a true audiophile anyway .. So, the question is how would I need to prep the RSW-10 sub to run the MCACC auto-calibration? - what should be the sub volume setting (medium, high)? - should I toggle the low pass filter on or off? - If low pass filter is enabled, what low pass frequency should I set it to? (With my old receiver I normally kept the low pass filter at about 80Hz) Thank you for your input. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.