Nirvelli

Somebody tripped over the control box cable on my Ultra 5.1's and it pulled out the cable from the sub. They plugged it back in, but now the system doesn't work. I can turn on power from the control box, and the buttons and lights do everything they're supposed to, but nothing happens at the sub. No familiar "pop" when the power comes on, no sound, nothing. I have opened the control pod and continuity tested the pins on the DIN end to the connections labeled on the board in the control box, and it looks like the cable is the problem. I am following the diagram shown here: http://www.thompdale.com/bash_amplifier/5-1/Control_pods/5.1_din_plug-415x211.gif I am hoping this is just an issue with the control pod, or maybe even just with the DIN cable. Is there any where I can get a replacement control pod or DIN cable?

---------------- On 1/17/2005 6:30:52 PM Savona wrote: That seems like an absurd amount. ---------------- Most would say that, but then, it isn't very likely that anyone else could/would sell you one for cheaper. I have one and I wouldn't sell it for much less than that. It's good stuff.

What is the cheapest good powered sub I could get then?

LoL... I'm not looking for used. BTW, where and for how much did you get your SWS?

I have a "5.0" speaker system and use the Klipsch DD-5.1 for a decoder. I am looking for a good powered subwoofer to put in, but can only spend $100. What would be the best to buy? I am also probably going to get the ProMedia 5.1 Ultras within a year, so it would be good if i could use the sub with that too. Thanks.