tiggs

Richard, Thanks for the tip, I have used half.com previously. Cheers

Anyone have a recommendation?

Have a new set of RF-7s. Just wondering what is a recommended brand and gauge. 10 feet distance is needed. Also, do you connect yours using bare wire? I'm not going to biamp or biwire. thanks

Actually, I was wondering how I could mount the RS-7s using the key holes? Would I just mount it like a picture with a screw? Or is there a bracket that will fit in there and mount that to the wall? What size screw should I use? Sorry for these stupid questions.

http://www.klipsch.com/product/product.aspx?cid=367 Here is the speaker. If you go to 360 degree view on this page you can see the back where there are mounting holes. Im sorry, I meant "on wall" not in wall. I have am going to run a 7.1 setup using my Denon AVR-5803. Two of the side surround RS-7s were going to be put on stands. Anyone know a particular stand that will work well with these speakers? Something 48 inch would be fine. The other two rear surround RS-7s are going to be mounted high in the corner. I dont not want to put a shelf unless absolutely necessary. As you can see I need the flat speaker wire that is paintable.

Is there a separate mount I can buy to attach these to a wall. I would like to have them installed in the corner of my room just below the ceiling. What would be the best solution. Also, I can't run the wires through the walls so I am looking for the flat paintable speaker wire. Thanks for anyone's input.