carloslara

thank you so much for your advice, to be honest using all the channels at 80hz, and low pass frequency at 120hz, is very, very plenty. did you have experience, calibrating 2 units RT12D , connected on cascade one each other, i mean, the LFE cable from the receiver to the first RT subs, and the second RT (rear), is connecting to the LINE OUT of the first RT. so when you run the ROOM CORRECTION, the first RT calibrated itself with the presence of the other, what i had test is this. using this method, the sound is good enough on the entire room, but i also test using "Y" monster adaptor to connect the two subwoofer from the same LFE port, and to be honest, using this, there's more boomie bass, but less accurate base response instead when do you use ROOM CORRECTION. opinion.?

RF82

very nice discusion post on the forum. i have a couple of tech question, since i've doing invesment on equipment, that i desire to be now my hobbie. my current setup is> front RF82, Center RC62, Rear Surround RS52, Back Rear Surround RS52 , with 2- RT12-D SUBWOOFER, using my Denon Avr-2310. i was reading on a great dedicated article on AVSFORUMS, about the right setting to each setup, and basics tips for accomplished or archieved good or excelent reproduction of the media. they told me to not use my front speaker as LARGE, always to use on SMALL setting, because that option only make sense when you don't have a subwoofer, make the amplifer on the LFE channel to send low frequency signal to the front pair speakers, make them sound to much boomies if you have subwoofer present. so they recommend to me to use 80hz on the high pass filter frequency for all the main speakers, set all of then to small, and the LFE channel set to 120hz, and LFE ONLY, instead of LFE + MAIN, which deny any low frequency to the main speakers and only leave the low frequency job to the sub woofer. in fact after make this, the sound came more clearly and crystal sound and the bass more satisfy. obviosly you feel the sound less boomie. here's my question, is my floorstand speakers RF82, are able to handle 30hz-23khz, even setting to small, will be adecuate to leave it on SMALL, and 80hz? i would like to heard your personal opinion or any other advice or experience by you member of this prestige forums. regards