I'm t'shooting a non-working RPW10 PCB. I do not own a scope; just a DMM.
I get no sound from the speaker, no hum nor the power-on thump.
Power LED lights and the fuse tests OK. Fuse tests OK and does not blow when amp is powered on.
Visually, the PCB is excellent: no smoked traces, lifted pads, blown caps a/o burned resistors.
No odor of burnt electronics.
I get ~26.3vDC across the voltage regulators.
I get ~5.6vDC across the two large resistors (volume at min.).
With board unplugged, I see normal cap drain-down: voltage drains to zero volts when measured across the voltage regulators.
Thus the usual culprits all appear to be normal.
What do I need to test next?