Jump to content

Search the Community

Showing results for tags 'biamping'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Klipsch Announcements
    • Klipsch News
    • Klipsch Pilgrimage 2020
    • Klipsch Website & Forum Info
  • Klipsch Museum of Audio History
    • Klipsch Museum: News & Announcements
    • Ask the Historian
    • Klipsch Museum: General Discussion
  • Klipsch Audio
    • General Klipsch Info
    • 2-Channel Home Audio
    • Home Theater
    • Subwoofers
    • Architectural
    • Klipsch Pro Audio
    • Technical/Restorations
    • Headphones
    • Personal Music Systems
    • Talkin' Tubes
    • Solid State
  • The Klipsch Joint
    • Garage Sale
    • Lounge


There are no results to display.

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





My System

See My System

Website URL








Found 2 results

  1. I just bought Palladium 37F's and jumped them into a system that had a pair of RF7's. I've been biamping the speakers by utilizing the unused rear effect amp, same as I did with the RF7's. I'm worried that I'm underpowering the Palladiums. I have an Arcam380 AVR, 90W x 2 channels, 75W x 7 channels. With the RF7's being 8ohms and the Palladiums being 4ohms, do I run the risk of frying the receiver or worse the speakers. I've tried to read some technical threads and articles about the 4ohm/8ohm discrepancy but get lost in the jargon. Can I preamp out just the low frequency channel to a separate amp. (I have an old Hafler XL600 I could utilize for this purpose.) I'm not looking to spend any $ at this time on equipment upgrades, I didn't even want to spend the money on the speakers but at the discounted price I pulled the trigger. Any advice would be great. BTW, the sound improvement between the RF7's and the Palladiums is dramatic.
  2. So I'm a total noob and need some assistance from the community here... I've got the most basic setup possible, however I still can't figure out how to maximize my speaker's potential! I've recently acquired a set of RB-35 bookshelf speakers and have set them up to my VSX-822 receiver. The receiver is a 5.1 channel, however I only have these two speakers and my dad took back his DOGG floor speakers... Anyways, I currently have them Bi-wired (at least I think so?) to the L and R on the receiver. There are still 3 open ports for a center and 2 surround... The back of the RB-35s have dual binding posts. I'm currently at work but found this picture on Google that is exactly how I have mine setup currently: [see attached] So am I best off with this setup? The single wire essentially comes from the L output of the receiver, and splits to both binding posts on the speaker... Same for the R speaker. Or should I run a separate wire from the L to the bottom or top binding post, then a separate wire from the L surround to the bottom or top binding post? I figured that would be too much power to the speaker and damage my goods... Any help would be greatly appreciated! I can take better pictures when I get home if needed! Thanks guys! BTW, I know I probably need more speakers in my setup... I'm saving up for a Klipsch center, but just graduated college and money is tight right now so speakers are last on my list unfortunately
  • Create New...