Klipsch sub and Yamaha receiver

[kass2178]

I am having difficulties connecting my subwoofer (Klipsch
SUB-10) to the receiver (Yamaha RX-V463BL). I just recently found out that I
needed a subwoofer cable to connect the two. I'm still a little weary on how
exactly to do this as I don't know much about the setup and the manual isn't
geared towards beginners. Any help would be greatly
appreciated, and thanks in advance.

[nzorn]

You just need a subwoofer cable: http://www.monoprice.com/products/product.asp?c_id=102&cp_id=10236&cs_id=1023603&p_id=2680&seq=1&format=2

Or found at any electronics store, you could buy a monster brand cable too, but you'd be shelling out more money, that's up to you.

It will connect to the back of your receiver in the Subwoofer Output port and then to the back of the subwoofer.

[kass2178]

Is this the only conection needed between the sub and receiver? Because if so, I made it a lot harder than it had to be...

[nzorn]

Yup, 1 cable is it. Then plug it into power and you're all set.

[kass2178]

Thank you very much for you help

[dougdrake]

And you probably need to go into the Yamaha's set-up menus and tell it you have a sub-woofer connected and then set the speaker sizes to small, and then set your cross-over settings (unless your Yammy has one of them new-fangled auto-calibration routines involving placing a microphone in the room and pushing GO).