Jasonscott Posted January 31, 2009 Share Posted January 31, 2009 I just ordered a pair of r-3650-w in wall speakers and iv found exactly where i want to mount them, but the wall studs are only 9" apart in that particular spot. the hole dimensions off this site say an 8" wide hole is needed, so that will give me about only a half inch for each dog leg to come out and clamp the wall. Do you think this would be enough? Is there a way to cut right next to one stud and mount that side of the speaker directly to the stud, so than i could have a full inch on the opposite side for the dog legs. Any help appreciated thanks alot! Quote Link to comment Share on other sites More sharing options...
Klipsch Employees Trey Cannon Posted February 4, 2009 Klipsch Employees Share Posted February 4, 2009 Yes, the "post" that the dog is on has a "wing" that will set next to the stud. you can put a screw through that wing into the stud. It will work fine. Hold the dog on that side in place and tighten the screw that moves the dog. that way it will not buzz. Quote Link to comment Share on other sites More sharing options...
Klipsch Employees Trey Cannon Posted February 4, 2009 Klipsch Employees Share Posted February 4, 2009 BTW: welcome to the forum! Quote Link to comment Share on other sites More sharing options...
Jasonscott Posted February 4, 2009 Author Share Posted February 4, 2009 Hey thanks alot, gonna be ordering some rf 82's or 83's soon, so youll probably be seeing lots more of me! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.