New RW-10d not seen by Pioneer MCAAC, overlooked something?

[djnick]

ok but did u do what i said lfe to 0 ? in sterio on sub set itto 80 did that work ?

[djnick]

such new technogies proably needs firmware update my harman kardon has port on back i can just upload myself to fix issues

like that sumtimes

but be sure says sw on in sterio and lfe is set to 0 meens on k and on klipshe sub set the cross to 80 hertz k

[CECAA850]

I called up Pioneer. Without much fuss, they said it was a receiver problem. Getting a replacement (in a month). Still, I wish I had another sub to be sure.

A different receiver ran your sub just fine. I agree on the receiver being at fault.

[0ctane]

such new technogies proably needs firmware update my harman kardon has port on back i can just upload myself to fix issues

like that sumtimes

but be sure says sw on in sterio and lfe is set to 0 meens on k and on klipshe sub set the cross to 80 hertz k

With the exception of a 100Hz crossover, yes, I tested this. I also tested on the THX setting which automatically uses 80Hz.

With a couple other people reporting a similar problem on that avsforum thread, and pioneer's quick phone response, it might be a known issue. Since I am only watching movies right now, I can direct connect my PS3 to the projector and use toslink to my Yamaha for sound. At least that way I will be able to use my RW-10d until the new receiver shows up.