stirling Posted April 21, 2002 Share Posted April 21, 2002 I've never been offered a bi-amp configuration on the speaker inputs until I got these KLF 20's! I'm running a Denon AVR 3802, how do I wire the front L & R speakers from the receiver? I'm online, but my thread says I'm not. Maybe I could use some help with that too..... THANNKS! Stirling This message has been edited by stirling on 04-21-2002 at 01:49 PM Quote Link to comment Share on other sites More sharing options...
dougdrake Posted April 22, 2002 Share Posted April 22, 2002 Hi Stirling - You can only bi-amp if you have two amplifiers. If you want to bi-wire, remove the jumper straps on the KLF-30s, then run two complete sets of speaker wires back to the Denon. At the speaker end, hook one pair to the upper posts and one pair to the bottom posts. At the receiver, hook both positive wires to the positive binding post and both negative wires to the negative binding post. Doug ------------------ My System Quote Link to comment Share on other sites More sharing options...
dbflash Posted April 22, 2002 Share Posted April 22, 2002 Try this site. It should answer all your questions. danny www.davidmannaudio.com/faq/faq3.html Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.