drumdude Posted January 23, 2013 Share Posted January 23, 2013 Hello I'm new here and have loved my 2.1 system for about 10 years. Except for that damn connector. I have read many posts on here and most all refer to the din connector cable or male end. I wish mine was that simple. I have broken pins on my internal conection on sub. I have taken off the broken piece off the IO board. On both pin outs I have found, none of them tell me which pins go where. I know that JK201-1 is for +15 v, JK201-2 is for sub etc. It has eight possibilities.Two rows of four not six on top of each other like the pin outs show and not marked on the board. I have a pin broken out of one of the six so I was going to solder my connections from the cable straight to the IO board. Out of these eight, what goes where??? Quote Link to comment Share on other sites More sharing options...
mustang guy Posted January 23, 2013 Share Posted January 23, 2013 You had a reply in your post in the Tech forum: http://forums.klipsch.com/forums/t/170775.aspx Click to go to that thread... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.