blue13x Posted August 28, 2021 Share Posted August 28, 2021 Hi. I use the Klipsch RP-502S using wall brackets that connect through the threaded insert, according to the manual it's 3/8-16 x 0.5". I am using the Konig & Meyer 24185 wall mount: Speaker wall/ ceiling mount These use the exact same threaded connector and held the speaker upright without any problems. However the material surrounding the threaded insert started to bubble up. The dealer replaced the speakers with new ones, but I am afraid this will happen again once I hang the new 502s. Was this an isolated case with a defective speaker or is the threaded insert not meant to carry the weight of the speakers? Quote Link to comment Share on other sites More sharing options...
MTMarshall Posted October 13, 2021 Share Posted October 13, 2021 Does the 502S come with mounting brackets? Quote Link to comment Share on other sites More sharing options...
NarcissusV Posted June 13, 2022 Share Posted June 13, 2022 (edited) I'm looking to mount a pair of these same speakers, possibly using the same mount, but after seeing your post I am very hesitant. What was the end result after receiving the replacement? Was the stressed threaded insert a one-time issue? Edited June 13, 2022 by NarcissusV Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.