M6 Driver Posted February 10, 2004 Share Posted February 10, 2004 Last night I had enough of a rattle in my LF10 so I got up enough nerve to do a little interal snooping and found that one of the circut boards was a bit loose a little coaxing later and rattle begone! Well this is where I ran into a problem I disconnected the +/- wires from the woofer without marking them. Is there a simple way to check phase and if it's off would flipping the phase switch on the back correct it? Still learning! Quote Link to comment Share on other sites More sharing options...
formica Posted February 13, 2004 Share Posted February 13, 2004 ---------------- On 2/10/2004 8:57:23 AM JTS8 wrote: Is there a simple way to check phase and if it's off would flipping the phase switch on the back correct it? ---------------- I'm not sure on the interior of the LF10, but most speakers have different size clips for the +/-. If all else fails, Yes, the switch would do the trick. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.