RoseRx
Regulars-
Posts
26 -
Joined
-
Last visited
Content Type
Forums
Events
Gallery
Everything posted by RoseRx
-
I have not seen > 1" @ the Depot or Lowe's.
-
Islander, Thanks for the tips. I don't really need 100', closer to 40-50', so I may try some of the local commercial electronic shops to see if they sell it by the foot. Unfortunately, I live in a medium sized city, so availability and demand might be working against me.
-
Where is the best place to buy large diam 1.5 to 3" wire loom, as it looks like a bowl of spaghetti behind my component stands? Are there any cables/wire that should not be housed together?
-
Success has been achieved! My unit apparently reset itself after being unplugged x 48h. You don't know what a relief it is not to have to disconnect everything, haul it to the repair shop, then rehook everything back up, not to mention a repair bill. Thanks again for all of your help! P.S. I posed my same problem to a couple other web sites w/ only a smattering of responses vs the doz or so replies here. This is the one for true adiophiles!
-
I have ttied the Impedence Selector in both positions, but nothing happened.
-
Ubfortunately, the power strip is OK. That would have been the easiest solution vs unplugging everything & hauling all 64lbs into the repair shop. I also unplugged & replugged the speaker wires, but that didn't help either.
-
I bought it used from a guy that was moving overseas. How can I tell the age of the unit and is the warr transferrable? I went to the Yamaha site & there are no auth service centers within 100 mi of where I live. I will try unplugging the spkr wires, however. Thanks!
-
I appreciate your help & advice, but the unplugged x 5 min didn't help. I can't find a fuse on the back panel, so it must be internal. I guess I'll have to unhook everything, which I am dreading & take it in for servicing. There are no authorized Yamaha service ctrs where I live, so I going take it to an independent or maybe Best Buy. I know there is prob a $25 diag fee, which can be applied towards the repair.
-
I checked the outlet w/ a hair dryer & there is juice.
-
James, Thanks for your reply. I also replugged it directly into the wall and nothing. I looked for fuses in the rear panel, but I didn't see any. There is no mention of fuses in the owner's manual, so they probably don't want to encourgage wannabe techs. Glenn
-
I was switching surge suppessors earlier today and now my Yamaha RX-V1 A/V receiver won't turn on manually or w/ the remote. I followed all the trouble shooting recommendations e.g., unplug x 1 min & replug, reset Impedence Selector. Any recommendations?
-
Fish, I'd read somewhere that 48" was the magic figure for dead center, so my dead center right now is 67" vs your 42". Luckily mine has a tilt mount and I have it angled down as much as possible. My stand for the center channel speaker is right below the TV, which prevents me from lowering the plasma anymore than 6". R
-
The bottom edge of my 50" set is 51" above the floor & my couch is 14-15' away. The TV height seems fine when you are standing, but I was wondering if it should 6" lower, since most viewing occurs in the seated position. What is the mounting height of most of yours?
-
I found the device I needed on E-bay, Electroline 4-Port Standard 1GHz Cable TV Amplifier. Thanks!
-
I was told that the surge suppressors that accept A/C power cords and cable, decrease the cable signal. Would a pre-amp device upstream from the suppressor offset the loss? If so, any economic recommendations for signal pre-amps?
-
Yes, the 092-626 or 092-628. Which is better 22ga vs 26ga? I only need a pair of them. Can they be bought locally e.g., CC, BB, Home Depot? I would also hate to spend a lot of $ on a crimper, that I may never use again. Any suggestions?
-
I have run my RG6 Quad cable & now I need RCA jacks. Who sells them in small quantities & what about a crimper?
-
Should I be powering down my subwoofer when it's not in use? If so, I could plug it into an aux outlet in the back of my receiver, so when I turn off the receiver, the subwoofer is off.
-
I took 2 readings, but I grasped your concept. Thanks!
-
Is front & off-center the optimum location for subwoofer placement? I was thinking of placing my black RSW-10 along the back wall, besides the couch, beneath an end table, rendering it less obtrusive. It just kind of looks out of place with the cherry finished speakers. Am I emphasizing aesthetics over acoustics?
-
It goes up one wall thru an attic crawl space due to a vaulted ceiling, then down the rear wall. If the ceiling was not vaulted, it would be a straight shot across the attic. I guess I could run the cable next to the baseboard or place the sub-woofer upfront, near the receiver.
-
CAS, Thanks for the advice. It's obvious I have a lot to learn. Will it be a problem to run 70' of single shielded RCA signal cable & where it the best place to order it? I ordered my unshielded 14/2 spkr wire from Parts Express. Should I have ordered "shielded" spkr wire for the rear bookshelf spkrs?
-
What's up w/ Axiom spkrs? They look nice & are priced right, but I noticed that they don't have the mass of the Klipsch.
-
I ran high-strand 14/2 O2-free CL3 thru the walls for my rear RB 35 bookshelf spkrs. I have decided that my RSW-10 subwoofer needs to go besides the couch on that same back wall. Will the same cable be OK to run for the sub-woofer?
-
Fish, Thanks for the encouraging words. From the stats on your system, it puts mine to shame. P.S. I also P/U a Yamaha RX-V1 A/V receiver for $800 from the same guy.