m.bartsch Posted January 22 Share Posted January 22 Hello all, This is my first time using Klipsch speakers and first time setting up something this advanced. I recently purchased the speakers below from Crutchfield; RP-8060 FA (2x) - Floor Standing RP-600C (1x) - Center RP-600M (2x) - Surround RP-1600SW (1x) - Subwoofer My receiver is a Yamaha - RX-A6A 9.2 Channel The fronts and the surrounds have the ability to be bi-wired. The fronts also have the Dolby Atmos speakers on top. Just wondering about how to wire everything up so it works correctly. Pretty easy to figure out the subwoofer and the center channel but how would I go about wiring the fronts and the surrounds? Would I Bi-wire the fronts and attach them to the Front connections then wire the Atmos speakers to the Front Presence? Same with the rears, would I Bi-wire these and attach them to the rear connections? Any help would be much appreciated. Quote Link to comment Share on other sites More sharing options...
The History Kid Posted January 22 Share Posted January 22 Bi-wiring wouldn't get you anything. Especially on an AVR. Just use the jumpers and run one set of cables from the speakers to the terminals. You'll run your rears to the rear surround (or side surround) terminals, and the atmos to the height terminals. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.