Rbalboa Posted April 7 Share Posted April 7 Hello! Today my Klipsch KDA-1000 was off. I tried to turn it on and off and it did turn on for a second (red light on) and then went off again. I unplugged the power for 15 minutes and just in case I connected the Ethernet cable to avoid IP issues. when I turned it on did the same thing, red light flashed for a second and then turned off. please help! thanks! 1 Quote Link to comment Share on other sites More sharing options...
billybob Posted April 8 Share Posted April 8 Not sounding good. Did you find the external fuse, usually located at or near the power cord. Welcome @Rbalboa Quote Link to comment Share on other sites More sharing options...
Rbalboa Posted April 16 Author Share Posted April 16 Thanks for your reply. Fuse is good. Regards 1 Quote Link to comment Share on other sites More sharing options...
billybob Posted April 17 Share Posted April 17 2 hours ago, Rbalboa said: Thanks for your reply. Fuse is good. Regards Bumping this up...may take a tech. Thanks for getting back. Quote Link to comment Share on other sites More sharing options...
Rbalboa Posted April 17 Author Share Posted April 17 Thank you! 1 Quote Link to comment Share on other sites More sharing options...
OO1 Posted April 17 Share Posted April 17 On 4/7/2024 at 6:03 PM, Rbalboa said: my Klipsch KDA-1000 was off. I tried to turn it on and off and it did turn on for a second (red light on) and then went off again. Start by updating or re-installing the Firmware of the KDA-1000 , as the FW may be corrupt following a surge or transient -if the FW update does not download or resolve the issue , the problem could be related to a Hardware issue KDA-500/1000 DSP Firmware Update https://support.klipsch.com/hc/en-us/articles/360034613932-KDA-500-1000-DSP-Firmware-Update https://assets.klipsch.com/files/KDA-Amplifiers-Firmware-Manual.pdf Quote Link to comment Share on other sites More sharing options...
Chiroklipsch Posted Friday at 12:30 AM Share Posted Friday at 12:30 AM My kda1000 doing same thing. Problem is the dsp is not accessible via ip address therefore I can’t update firmware? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.