rtaylor Posted June 15, 2003 Share Posted June 15, 2003 Getting a little confused on the finer points here. (1)How critical is the 0.02 mf caps impedance? (2)The 6800 ohm resistor that went from electrolic capacitor lug one to lug two, is this now getting mounted on the new power supply board? (3)The dual bias? Back to studying the roadmaps.(instructions) Quote Link to comment Share on other sites More sharing options...
rtaylor Posted June 15, 2003 Author Share Posted June 15, 2003 On the sds capacitor board where it is marked power transformer b+ windings or cathode of 5ar4 is pin #8 the correct one to use? I'm assuming it is because the choke went to #8 on the original, and if so do I connect a jumper across the other.What about the ground hooked up to the V1 socket,does this go anywhere now? Quote Link to comment Share on other sites More sharing options...
NOSValves Posted June 15, 2003 Share Posted June 15, 2003 You need some phone coaching You have mail ! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.