DSI77 Posted September 27, 2004 Share Posted September 27, 2004 Hello I seek an amplifier has valve for my speaker KLF20. 2a3 6l6 845 or 300b ? What advise me? Thank you Quote Link to comment Share on other sites More sharing options...
Klipsch RF7 Posted September 27, 2004 Share Posted September 27, 2004 Bonjour Monsieur Budreaux, I would recommend a pair of Dynaco Mark III power amps, with a tube preamp to go with your KLF-20's. You will have great bottom end, nice midrange and smooth highs. Get a pair of the Dynaco's and get the Valve Art KT-88 tubes, get the Triode mod and run them in Triode mode. I have that same setup except with RF-7's and it sounds amazing. Those KLF-20's are amazing for rock! They have the midrange driver with the double 10" woofers and big cabinet, they hit hard!!! Quote Link to comment Share on other sites More sharing options...
Guy Landau Posted September 27, 2004 Share Posted September 27, 2004 You already have a very nice sounding Audio Innovation amp. I don't think that Dyna MKIII's will make a big improvement. What kind of music do you normally listen to? How big is your room? Quote Link to comment Share on other sites More sharing options...
DSI77 Posted January 13, 2005 Author Share Posted January 13, 2005 Hello Yes the se500 walk already very well it is tweaké. I think that I will keep it for the moment. I listen to jazz of traditional and variety. My part of listening made 30m ² 6 meters X 5 meters (I am French) Thank you Photographie ir : http://fr.f2.pg.photos.yahoo.com/ph/dsi77photo/album?.dir=/8374&.src=ph&store=&prodid=&a Quote Link to comment Share on other sites More sharing options...
Colin Posted January 13, 2005 Share Posted January 13, 2005 not 2a3 tubes (valves) unless room is small (3-4 meters by 3-4 meters) and music is low (<95dB) Quote Link to comment Share on other sites More sharing options...
DSI77 Posted January 14, 2005 Author Share Posted January 14, 2005 UP Quote Link to comment Share on other sites More sharing options...
leok Posted January 14, 2005 Share Posted January 14, 2005 A 2A3 SET, output impedance set for 4 Ohm, would sound very good at moderate volumes. When I want very loud I either offload bass using a subwoofer with active crossover, or switch to one of my "big" 8W amps. I would expect there would be times when you would want more power. But for excellence at moderate to low volumes, the 2A3 would work. Can you borrow one to try? A 300B may work better for you due to more power. But, you should compare. You may prefer the sound of the 2A3. Leo Quote Link to comment Share on other sites More sharing options...
DSI77 Posted January 14, 2005 Author Share Posted January 14, 2005 Hello and thank you I did not test a 2a3 yet nor but a 300b. I also will test a se845. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.