Tobias

Yes, same issue. Yes, considerable less, but yes.

Subs connected to the same outlet. Testing only with one sub on. 2 prongs connected, normal and reverse = 3 prongs I found a little difference: no rca, minimum hum. WITH RCA (2 different cables) = hum

yes, 3 prongs.

Ok. I hear the noise when no music is played. If I unplugged the rca cable and the amp is on, still hum noise. (must return to english lessons jajaa)

Thanks guys for your fast answers! Yes, it's 220v from factory.

Both units, gain set about a little less than half, -7 on receiver. I tried in other room, same problem. 220v here.

Hi. I have humming noise from my R-115w (2 units) I try with different cables, no luck. If power switch is on, but the amp didn't turn on, no hum. If amp turns on, with or without rca cable = hum. If I turn the crossover to 40, no hum, in LFE mode = HUM. Any ideas? Thanks.

ajajaja

Thanks TwoCables! thanks guys!

So what about ALL the "subwoofer cables" reviews on Amazon? all buyed opininions? because a lot of people experiments differences between cables...

Thanks Bill. I can buy ANY cable in the USA, I have a contact that imports it to my country.

Thanks for the reply... so... is there a myth about cables?

Hi guys, I just recently buy an R-115SW as a second subwoofer in my set up, and I want your opinions about a good subwoofer cable, Regards from Argentina.

Up!

Thanks Youthman! but I want the " II " versión.

Ok, thanks anyways!

Hi guys, I'm looking for a pair of RS62-II surround speakers, in perfect condition, shipped to Miami, would you like to help me? Regards from Argentina

Thanks again. I tested, volume from -30 to -10 in stereo, I didn't notice any difference... []

Thanks guys! My last question: is it safe to test the speakers at 6 or 4 ohms? (for the speakers and receiver)

Yes, 8, 6 and 4 ohms. Wil it sound different? more power? Is it safe? I also have a RC-64II, and a pair of 82II for surround.

Hi. Is it possible to run the 7II's at 4 ohms with the AVR-A100? or I'm forced to use at 8 ohms? Thanks!

I send signal from my X-Fi, with a W7 x64 plataform, to a Denon receiver, sometimes it didn't sound well, I had to put the level signal to -4db to get a less distorted sound. Maybe in your case, you can try puting your source signal volume down. Saludos!

I'm a little confused... I have a Denon 3311ci and the RF-7II of course, and I'm planning to add a XPA-2 for better and louder stereo playback... would I get some real possitive difference or not? Thanks!

Yes... Indeed... that was I was finding out... so... what are my options? Thanks!

Yes! an Emotiva, for example... (I'm foreigner... excuse me... my native language is spanish)