oldslow Posted December 29, 2010 Share Posted December 29, 2010 I recently aquired a set of Athena S3/P2 speakers ( http://www.athenaspeakers.com/products/s3-specifications/) to use a rears. I'm trying to figure out how to best set them up to use the Audysessy calibration. I have the RF-82's as mains. RC62 as center. Does anyone have any suggestions? On the P2 is a bass response from 50 to 150 and a volume. I guess I kinda am wondering where I should set that bass response before I run the Audysessy. Also Audysessy always sets the mains as full band on the Onkyo 805. I read that most folks suggest not using full band? What do you guys think? thnx Quote Link to comment Share on other sites More sharing options...
smokarz Posted December 29, 2010 Share Posted December 29, 2010 i too have the 805. after audyssey setup, goes into speaker config and change them to "small". Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.